just overclocked q6600 can you check if i did it right

hey, i just overclocked my q6600 and i wanted you guys to make sure i have my voltages and everything else correct

Everything looks fine to me, although your voltage seems to be a bit high for only 3.26GHz. But then again you do have the B3 stepping.

i ran orthos for 30 minuites but then i stoped it cause im gonna go to bed my cpu temp stayed at 35.5 but core 1 and core 2 went to 60-70c while both at 100% load and when i stopped orthos the 2 cores shot from 70c to 40-50c



how come pc wizard is telling me that my cpu temp is 35.5 right now when core 1 is 47c and core 2 is 44 and core 3 and 4 are 40

because pc wizard sucks... i always use everest

Those temps are too high, id expect more from water, do you have any kinks or elbows in your tubing?

What is your stock voltage, and what did you set it to in the BIOS?

It depends of that screenshot was taking right after he ran a stress test, or if it was just idling for several minutes.

I'm on my iPhone but my radiator was freezing but after 20minuites it got worm, do u think I can increase the FSb with the voltages I have

Just try, it will be quicker and more accurate than waiting for a reply

i just overclocked farther but i just randomly put the voltage up with out restarting and seeing if it will boot, buit now it does and on cpu-z it runs at 2.4 or 3.5 maby to save electricity



but what is wierd is that pc wizard dosnt detect my board nor voltage e.c.t