hello everyone, i got 2 dvd-RW's one master and the other one slave and i have update both there drivers but there both not reading dvd's or cd's like there spouse to be doing
Please help, Thank You
Did you plug the power connector into them? And did you plug in the IDE cable to them and to the motherboard? If you did, did you connect them the right way?
Was this answer helpful ?
Yes No
yeah both the dvd-RW's are working alright and i got these Round blue Female IDE calbes x2 but i'm really not sure if there connected the right way i'll see if i can get and img, one end is Black and the other is Blue
Was this answer helpful ?
Yes No
The blue end should plug into the motherboard, then there should be a big gap, then another connector, a small gap, and another connector. Those 2 last ones should be plugged into your drives.
Was this answer helpful ?
Yes No
it looks sort like this one
http://www.pccasegear.com/prod1648.htm
Was this answer helpful ?
Yes No
ok now the slave is working alright but the master is'nt and i've got noth the blue ends hooked up to the mobo, any thoughts?
Was this answer helpful ?
Yes No
Do you have any extra ide slots on the board, might try hooking both of the dvd-rw's up seperately. The slave works, try making it the primary slave, and see if the other will work as master on it's own.
Was this answer helpful ?
Yes No
i just have the 2 IDE slots and both of them have been hooked up, 1 master and one slave
Was this answer helpful ?
Yes No
i'll try making them both master and if that does'nt work i'll try making them both salve and i'll get back to you if it works or not
Was this answer helpful ?
Yes No
So you have a sata hard drive, and the only ide devices you have are the 2 dvd-rw's and they are both on seperate ide's? They should both be master if this is the case. Check in bios that the IDE detection is set to auto detect.
Was this answer helpful ?
Yes No